24
Rear-end oil change
1. Place the trike onto the center stand on a suitable
lift.
2. Remove left rear wheel and support trike.
3. Drain rear-end oil from both gear case &
differential see diagram for drain plug locations.
4. Remove both the check level and the fill plug on
gear case
5. Remove the fill plug on rear differential
6. Install both drain plugs.
7. Refill with 80/90 GL5 rated oil (non-synthetic)
8. See diagram for oil amount do not over fill.
9. Replace gear case check level plug hand tighten
only.
10. Replace both differential & gear case fill plugs.
11. Replace wheel.
12. Remove from center stand and enjoy the ride.
Specifications:
1. Differential drain plug 22 ft-lbs.
2. Rear wheels 70 ft-lbs.
3. Both differential and gear case fill plugs 22ft-lbs.
4. Gear case drain and check level plugs hand tighten
only.