14
2010 to current
C.V. Boot Replacement
Removal of the half shaft:
1. Raise the rear end off the ground and properly
support it in a stable position.
2. Remove the rear wheel.
3. Remove the half shaft nut from the wheel bearing.
4. Remove the safety clip and roll pin lower control
arm to the upright
5. Pull down on control arm to remove from upright.
6. While pulling downward on the half shaft rotate the
upright upwards and remove the half shaft from
the wheel bearing.
7. Support the upright in the upward position.
8. Next remove the half shaft and stub shaft assy.
from the kit.
Removal of inner C.V. boot:
1. Cut and remove both the small and large C.V. boot
clamps.
2. Clamp the shaft in a vise with the inner C.V. joint
pointing upwards.
3. Slide the C.V. boot down the shaft.
4. Remove inner wire retaining ring from the C.V. joint
outer race.
5. Pull the C.V. joint outer race off the tripod joint.
6. Clean the grease from the tripod joint and C.V.
boot, place new grease back into the C.V. joint
outer race.
To Next Page
Loading...