CSC COBRA - Belt Drive Maintenance Schedule

4
Maintenance Schedule: BELT DRIVE
Frequency (miles) Daily 4k 8k 12k 16k 20k 24k
Item
Belts I I I I I T I
Brake Pads and Rotors [1] I I I I I I
Half Shaft Boots L L L L L L
Wheel Bearings [2] I I I I I I
Wheels and Tires I I I I I I
All Lighting I
Tire Pressure [3] I
Brake fluid I I R I I R
I: Inspect: clean, lubricate, and/or replace as necessary.
R: Replace
L: Lubricate with Silicone Spray
T: Tension
NOTE:
[1] Minimum pad thickness is 0.04 inches (1.02mm)
[2] Wheel bearing torque 200 FT.-LBS.
[3] Rear tire pressure 28 PSI
At higher odometer readings, repeat at frequency intervals established
here.
Note:
This Schedule is in addition to the Manufacture Maintenance Schedule
NOTICE:
The remote door opener installed on this unit has a very small electrical
draw on your motorcycle battery. If your trike will be unridden for more
than 2 weeks you should remove the 15 amp fuse from the red fuse
holder located under your seat or right side cover. Another option is
using a battery tender.