20
Cobra trike
Brake bleeding procedure:
1. Using a vacuum bleeder, follow this procedure
carefully.
a. Left front upper bleed valve.
b. Right front lower bleed valve.
c. Rear caliper rear bleed valves.
d. Anti-dive bleed valve.
e. Rear caliper front bleed valves.
2. Hand bleed the system using the above sequence.
Until all air is removed from the lines.
3. Allow the bike to set for a minimum of 20 minutes
and recheck.
4. If there is excessive pedal travel on the first pump,
repeat steps 1 through 3.
To Next Page
Loading...