CSC COBRA - Belt Drive Brake Bleeding Procedure

19
Belt drive trikes
Brake bleeding procedure:
NOTE: if ABS equipped DO NOT use a vacuum bleeder
hand bleed only.
1. Using a vacuum bleeder, follow this procedure
carefully.
a. Standard Brake Caliper
i. Using correct brake fluid, fill Rear Brake
Master Cylinder Reservoir.
ii. Bleed the right rear upper bleed valve.
iii. Bleed the left rear upper bleed valve.
b. Performance Brake Caliper
i. Using the correct brake fluid fill the Rear
Brake Master Cylinder Reservoir.
ii. Bleed the front Right Rear Caliper Bleed
Valves.
iii. Bleed the front Left Rear Caliper Bleed
Valves.
iv. Bleed the rear Right Rear Caliper Bleed
Valves.
v. Bleed the rear Left Rear Caliper Bleed
Valves.
2. Hand bleed the system using the above sequence.
Until all air is removed from the lines.
3. Allow the bike to set for a minimum of 20 minutes
and recheck.
4. If there is excessive pedal travel on the first pump,
repeat steps 1 through 4.
5. Top off the Rear Brake Master Cylinder Reservoir
with the correct brake fluid. Clean and reinstall the
Rear Brake Master Cylinder Reservoir Cover.