8
5. Slide the male splines into the wheel bearing.
6. Replace the lower a-arm and roll pin w/safety clip.
7. Lubricate the threads on the half shaft with loctite
and tighten the half shaft nut. Torque to 200
ft/lbs.
8. Reinstall the brake rotor.
9. Reinstall the brake caliper.
10. Reinstall the two 3/8 – 24 x 1 HHCS with Loctite
applied and torque to specification.
11. Reinstall the wheel assembly.
12. Remove the trike from the lift.
Specifications:
1. Lug Nuts 70 ft/lbs
2. Axle Nut 200 ft/lbs
3. Brake Caliper 30 ft/lbs
To Next Page
Loading...