CSC RX1E - Pre-Ride Inspection

.
18
.
Operation Guide
Inspection before driving
Before driving, check in accordance with the following requirements to ensure users' safe driving and successful driving.
NO.
Items
Check
Remark
1
Battery
Check if the battery has enough power.
Depending on how far and how
often you ride your motorcycle, you
should perform three levels of
maintenance regularly:
Level I Maintenance: From 600 to
1,500 miles, focus on lubricating and
tightening the parts.
Level II Maintenance: From 1,500
to 3,700 miles, check, adjust,
lubricate and tighten the parts.
Level III Maintenance: From 3,700
to 6,200 miles, do a thorough
analysis, cleaning, inspection and
adjustment of the parts. Lubricate
and tighten them as well. Replace
any worn
-out parts and fix any
potential problems.
We recommend that you take your
motorcycle to our authorized service
center for installation, tuning and
maintenance.
2
Drive device
Check whether the controller and drive motor are working properly.
3
Brake oil
Check whether the oil is deteriorated and whether the capacity is
lower than the lower scale line.
4
Brake handle
Check whether the
front brake has pressure.
5
Shock absorber
Check whether the
suspension works properly.
6
Throttle
Check
for smooth operation of the throttle.
7
Handlebar
Check
for smooth movement and full turning range of bars.
8
Tire/wheel
Check tire pressure and wear
9
Lighting/signal indicator
Check whether the lighting lamp/signal lamp/indicator lamp is
working.
10
Brake
Check the wear of brake shoes and whether the braking
performance is good.
11
Side stand
Check the
side stand for bending, deformation, and good return.
12
All
-vehicle fasteners
Check whether the fasteners of the finished vehicle are
tightened
securely.
Inspection