.
28
.
Inspection and adjustment of brakes
Inspection of hydraulic brake 1. Make sure the brake lever has the correct amount of free play
according to the manufacturer’s specifications. If the brake lever travel cannot be adjusted properly, it
means that the brake pads are worn beyond the service limit and need to be replaced.
2. Check the oil level of the oil storage cylinder from the observation hole. When the oil level of
the oil storage cylinder is lower than the lower limit position, the brake oil shall be replenished to
the upper limit position.
Recommended brake oil: DOT4
Standard value of free travel of brake handle: 10 mm ~ 20 mm
Caution
1. After you adjust the brake, squeeze and release the brake lever several times by hand. Then let go of the brake lever, spin
the wheel, and check if the wheel spins freely. Make sure you also adjust the rear brake light switch after you adjust the rear
brake.
2. When adjusting the brake and replacing the brake pads, please be sure to replace the original OEM genuine parts.
3. Schedule and perform the recommended maintenance service as recommended.
Maintenance
To Next Page
Loading...
