Why is the braking force reduced on my CSC RX3?
If you experience reduced braking force on your CSC Motorcycle, it could be due to worn brake pads. The solution is to replace the brake pads. Another possible cause is air intrusion into the brake line. In this case, you should bleed the brakes.
How to fix pulsating brake lever on CSC RX3?
If you're experiencing a pulsating brake lever on your CSC Motorcycle, it's likely due to a warped rotor disk. To address this, measure the disk runout and replace the disk rotor if necessary.
General| Compression Ratio | 11.5:1 |
|---|---|
| Fuel System | Electronic Fuel Injection |
| Starting System | Electric |
| Transmission | 6-speed |
| Final Drive | Chain |
| Front Suspension | Inverted Fork |
| Front Brake | Single Disc |
| Rear Brake | Single Disc |
| Front Tire | 100/90-18 |
| Rear Suspension | Monoshock |
| Length | 1, 420 mm |
| Wheelbase | 1, 420 mm |
| Engine Type | Liquid-cooled, single cylinder, 4-stroke |
Procedure for checking and replacing worn brake pads.
Troubleshooting common brake system issues and maintenance actions.
Steps for inspecting and adjusting valve gaps for optimal engine performance.
Diagnostic procedures for various engine performance issues.
Essential safety precautions when working on the cooling system.
Troubleshooting flow charts for common electrical system problems.
Diagnosing and fixing issues with weak starting motor rotation.
To Next Page
