CSI-1 Instruction Manual20
Troubleshooting
Fault appearance Possible cause Solution
The opener does not work Power Supply Check whether the opener is connected to power.
LED lights do not work The LED is broken Replace the LED
Poisiton missing System error Re-set the limit traveling
While learning, the digital display
Travel less than 30cm or more than 9m Re-set the limit traveling
Digital display
Opener does not work or stop working
Insufficient voltage Check the power supply
Digital display or Unbalanced spring Rebalance the spring
Opener is not working
Digital display
Opener failed to learn the UP and DOWN limit
setting.
Follow the Programming Instructions on how to set the open and close limits.
Door moves up only. Door will not
close.
Digital display
Safety Beam is obstructed Check there is not obstruction in the safety beams path.
The remote control cannot be used or
the operation distance is short
Flat battery
Antenna is loose or not well extended
Replace the battery
Extend the antenna on the opener
Digital display Stored remote code is full Delete all stored codes and only code remotes needed.
To Next Page
Loading...
