CSI-1 Instruction Manual4
WARNING!
• The door may operate unexpectedly, therefore do not
allow anything to stay in the path of the door.
• When operating the manual release while the door is
open, the door may fall rapidly due to weak or broken
springs, or due to being improperly balanced.
• The drive must not be used with a door incorporating a
wicket door, unless the drive cannot be operated with
the wicket door open.
• The drive is intended to be installed at least 2.5m
above the floor.
• Do not disengage the opener to manual operation
with children/persons or any objects including motor
vehicles within the doorway.
• If the door is closing and is unable to re-open when
obstructed, discontinue use. Do not use a door with
faulty obstruction sensing.
ELECTROCUTION!
• Place opener in protected area so that it does not get
wet.
• Do not spray with water.
• Disconnect the power cord from mains power before
making any repairs or removing covers. Only experienced
service personnel should remove covers from the opener.
• If the power supply cord is damaged, it must be
replaced by an suitably qualified person.
• Connect the opener to a properly earthed general
purpose 240V mains power outlet installed by a
qualified electrical contractor.
This automatic garage door opener is designed and tested to offer safe service
provided it is installed and operated in strict accordance with the following safety
warnings. Failure to comply with the following instructions may result in death,
serious personal injury or property damage.
Installation Safety Warnings
To Next Page
Loading...
