Chapter 5. Configure via Console Port
5-12
---------------------------------------------------
Command: setup shdsl margin <0~10|Disable>
Message: Please input the following information.
Set Startup Margin (TAB Select)<0~10>: Disable
------------------------------------------------------
--
SNR margin is an index of line connection. You can see the actual
SNR margin in STATUS SHDSL. The larger SNR margin, the better line
connection. If you set SNR margin in the field as 2, the SHDSL connection
will drop and reconnect when the SNR margin is lower than 2.
For configuring SHDSL PSD, move the cursor to psd and press [ENTER].
Select the parameter via [TAB] key.
---------------------------------------------------------------------
annex Configure shdsl annex
margin Configure shdsl margin
>> psd Configure shdsl psd
pwr_backoff Configure power backoff
framer Configure shdsl framer
To Next Page
Loading...
