Chapter 5. Configure via Console Port
5-13
--------------------------------------------------
-
Command: setup shdsl psd
<r1_asym|r2_asym|sym_enable|asym_disable>
Message: Please input the following information.
SHDSL PSD (TAB Select) <r1_asym>: r2_asym
------------------------------------------------------
--
The SHDSL PSD will enable the transceiver to use an asymmetric power
spectral density, as specified in the G.991.2 standard.
Possible values for PSD are:
r1_asym: 786kbps for Annex A, 2312kbps for Annex B
r2_asym: 1552kbps for Annex A, 2056kbps for Annex B
sym_enable: Symmetric and Asymmetric enable.
asym_disable: Symmetric enable but asymmetric disable.
For configuring power backoff, move the cursor to pwr_backoff and press
[ENTER]. Select enable or disable via [TAB] key.
---------------------------------------------------
--
annex Configure shdsl annex
margin Configure shdsl margin
psd Configure shdsl psd
>> pwr_backoff Configure power backoff
framer Configure shdsl framer
------------------------------------------------------
-
Command: setup shdsl pwr_backoff <enable|disable>
Message: Please input the following information.
SHDSL Power Backoff (TAB Select) <disable>: enable
------------------------------------------------------
To Next Page
Loading...
