EasyManua.ls Logo

CTM HS-268 - Page 21

Default Icon
68 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Number
of Flashes
Battery Low
The batteries are running low.
Recharge the batteries.
Low Battery Fault
The batteries have run out of charge.
Recharge the batteries.
Check the battery and associated connections
and wiring.
High Battery Fault
Handling method:
1.Disconnect the battery pack, and check
the battery condition.
2. SERVICE-6 Battery Pack Repair.
Current limit time-out or controller
overheat
Do not drive up steep slopes or overload
the scooter.
N-D lever not set to D-position
Electromagnetic brake failure
Switch to D (drive) position. Turn off the power and
turn on again.
SERVICE-13-5 Electromagnetic Brake Repair.
The throttle is not in Neutral or the
folding / unfolding procedure is
uncompleted.
Solution:
1. Repeat the folding or unfolding procedure.
2. SERVICE-1-3 Starter VR Repair.
The folding / unfolding procedure is
uncompleted
Repeat the folding or unfolding procedure.
Scooter battery is being charged
Turn off the main power and disconnect the
charger.
Micro switch failure
SERVICE-12-1 Micro Switch Repair.
Speed pot
SERVICE-1 Steering Cover Repair.
Motor or relevant circuit failure
Solution:
1. SERVICE-11-1 DR Controller Repair
2. SERVICE-13-4 Motor Repair
Main cable, controller failure or
controller temperature too high
Solution:
1. SERVICE-11-1 DR Controller Repair
2. SERVICE-2-1 Main Cable Repair
Possible Cause Handling Method
1
2
3
4
5
6
7
8
9
Service manual
19
Self-Diagnostic Warning Light :
Self-Diagnostic Warning Light
When the main power switch is turned on (4-2 Main power Switch Operation), The self-diagnostic warning
light will flash if there be any malfunction or failure.
Touch Version-self-diagnostic warning light, shared
with the battery indicator.
Manual Version-self-diagnostic warning light, shared
with the main power light.
Normal : remains on, as does the battery power
indicator.
Failure : flashes according to the nature of the
failure, see the table below.
Normal : constant green light.
Failure : flashes according to the nature of failure,
refer to the table below.