CTM HS-268 - Rear Fender Repair; Folding; Unfolding Board Repair

52
SERVICE - 11 - 4
Rear Fender Repair
Folding / Unfolding Board Repair
SERVICE - 11 - 5
Please follow the SERVICE-11 Rear Top Cover Repair steps for removal, then :
1.Disengage the locking pins on both sides of the rear fender and seat bar mechanism.
2&3.Remove the screws (12mm, 4pcs) on both sides of the rear fender.
4.Pull the rear fender back to separate it from the frame.
5Take the rear fender off.
※For re-installation, follow the exact reverse sequence of these steps.
Complete the steps of SERVICE-11 Rear Top Cover Repair to remove the cover, then :
1.Find the folding / unfolding board inside the Scooter.
2.Remove the two screws holding the board.
3.Take the board out.
※For re-installation, follow the exact reverse sequence of these steps.
•Step 4.When the N-D lever is in the D- position, the rear fender may not
be easy to remove. Shift the gear to the N position to make removal easier.