63
60+-6kgf-cm 60+-6kgf-cm
SERVICE - 13 - 4
Motor Repair :
The motor is heavy and this operation should be given the attention of two
people. One can support the motor while the other removes or replaces the
bolts, etc. The scooter should be turned over to make this operation easier.
•After the motor has been removed, set it aside carefully and do not drop
or damage it unless it is to be discarded.
•All the other parts, including the U-shaped fixing plates and the bolts and
nuts need to be kept because they will not be provided with a new motor.
Please carry out the SERVICE-11 Rear Top Cover Repair SERVICE-12 Rear Lower
Cover Repair SERVICE-5 Rear Wheel Repair steps, and then :
1.Use a wrench (#13) to hold the nuts on the right side of the frame and an Allen driver
(#5) to unfasten the bolts (30mm, 2pcs).
2.Follow the same procedure for the other side of the frame.
※The motor is quite heavy, be careful not to drop it when taking it out.
3.Remove the U-shaped fixing plates on both sides, and the motor can be taken out.
※When replacing the motor follow the same sequence of steps in exact reverse.
To Next Page
Loading...
