2-8 Safety Interlock Harness
Installation for the SZ Model
Remove the bracket and hardware shown in Figure 2-8g
to gain access to the SZ model safety interlock switch.
Use the instructions on the previous page as a reference
for routing the safety interlock wiring harness from the
PTO assembly to the safety interlock switch. Use zip ties
where needed, to secure the wiring harness P#(P0208)
away from all moving parts and all heat sources that
could potentially damage the wiring harness.
Locate the mower’s safety interlock switch as shown in
Figure 2-8h. Disconnect the mower’s existing wiring
harness from the safety interlock switch and connect the
safety interlock wiring harness P#(P0208). Connect the
mower’s wiring harness to the safety interlock wiring
harness P#(P0208). Replace the panel and hardware
removed from Figure 2-8g.
12
Figure 2-8g
Figure 2-8h
Remove
Hardware
Remove
Bracket
Remove
Hardware
Connect Safety Interlock
Wiring Harness Here
Mower’s Safety
Interlock Switch
To Next Page
Loading...
