CDR-3250/80 TECHNICAL ANNEX
Issue 2.1 Change 2
AN-1B
DC POWER SUPPLY OPTION
DESCRIPTION
This annex supplements the CDR-3250/80 technical manual and contains difference data for certain CDR-3250/80 models
containing a DC power supply.
DIFFERENCES
The major differences are as follows:
Item AC Version DC Version Remarks
Power Requirements 90 - 260 VAC 47 - 440 Hz, 50 watts 20 - 32 VDC, 3A maximum
Power Connector
(rear panel)
Connector Type - IEC 320-C-13
(CCI P/N 343-002) mates with
NEMA 5-15P (CCI P/N 696-012,
Power Cord)
Connector Type - MS3452W16S-1P
(CCI P/N 320-008) mates with
MS3456W16S-1S (CCI P/N 320-009)
Refer to
Pin
Description
table below
Line Filter
P/N 260340-1
P/N 2608-2015-1
Power Supply Module P/N 260259-1 P/N 118-083
DC POWER Connector (J1) Pin Descriptions.
Pin Signal Remarks
ANC
B POWER RETURN (GND)
CNC
D POWER RETURN (GND)
E +VDC IN +20 to +32 VDC, 3A maximum
F +VDC IN +20 to +32 VDC, 3A maximum
G SHIELD GROUND
Except for input power, the receiver functions identically to the AC powered CDR-3250/80 unit. Refer to Foldout 3.1 (FO-3.1),
on page AN-2B for the DC Interconnect drawing option.
Courtesy of http://BlackRadios.terryo.org
To Next Page