Cubic Communications CDR-3250 - Sweep

CDR-3250/80 TECHNICAL MANUAL
Issue 2.2 3-27
Scan/Sweep - SWEEP Soft Key Menu.
FROM TO OFFSET SWEEP DONE
MTR
MNU
NEXT
Press OFFSET (if desired) to offset the sweep squelch level during the sweep. The receiver adds the offset value to the squelch
level setting for each even channel in the sweep. The following menu appears if OFFSET is selected.
Scan/Sweep - SWEEP - OFFSET Soft Key Menu.
+/- BKSP ENTER RETURN
MTR
MNU
NEXT
Select the desired squelch offset setting and press ENTER. The menu will switch back to the Scan/Sweep - SWEEP menu as
shown below.
Scan/Sweep - SWEEP Soft Key Menu.
FROM TO OFFSET SWEEP DONE
MTR
MNU
NEXT
Press the NEXT key and the following menu appears.
Scan/Sweep - SWEEP - NEXT Soft Key Menu.
RATE SWEEP DONE
MTR
MNU
NEXT
Press the RATE key to change the sweep rate, and the following menu appears.
Scan/Sweep SWEEP - NEXT - RATE Soft Key Menu.
BKSP ENTER RETURN
MTR
MNU
NEXT
Change the sweep rate using the main adjustment knob and press the ENTER key. The following menu appears.
Courtesy of http://BlackRadios.terryo.org