CDR-3250/80 TECHNICAL MANUAL
3-22 Issue 2.2
Scan/Sweep - SCAN Soft Key Menu.
FROM TO OFFSET SCAN DONE
MTR
MNU
NEXT
Press the TO key and the following menu appears.
Scan/Sweep - SCAN - TO Soft Key Menu.
BKSP ENTER RETURN
MTR
MNU
NEXT
Select the desired ending channel using the keypad or main adjustment knob, and press ENTER. The menu will switch back
to the Scan/Sweep - SCAN menu as shown below.
Scan/Sweep - SCAN Soft Key Menu.
FROM TO OFFSET SCAN RETURN
MTR
MNU
NEXT
Press OFFSET (if desired) to offset the scan squelch level for all channels during the scan. The receiver normally uses the
squelch level set into each channel throughout the scan. The following menu appears if OFFSET is selected.
Scan/Sweep - SCAN - OFFSET Soft Key Menu.
+/- BKSP ENTER RETURN
MTR
MNU
NEXT
Select the desired squelch offset setting and press ENTER. The menu will switch back to the Scan/Sweep - SCAN menu as
shown below.
Scan/Sweep - SCAN Soft Key Menu.
FROM TO OFFSET SCAN DONE
MTR
MNU
NEXT
Press the NEXT key and the following appears
Courtesy of http://BlackRadios.terryo.org
To Next Page
Loading...