Cubic Communications CDR-3250 - Page 58

CDR-3250/80 TECHNICAL MANUAL
Issue 2.2 3-33
Utility - CONFIG - INIT Soft Key Menu.
CHNL SKIP MDFLTS SFLBLS CANCEL
MTR
MNU
NEXT
Press CHNL to initialize (clear) the memory channels and change them to factory default settings. The following menu appears.
Utility - CONFIG - INIT - CHNL Soft Key Menu.
CONT CANCEL
MTR
MNU
NEXT
Press CONT to continue or CANCEL to cancel the function.
NOTE
To confirm the factory default settings after
initialization, ensure the Mode Default
function is off. The memory channel factory
default settings are:
Frequency: 10.0 MHz Step size: 10 kHz
Receive mode: AM Dwell time: 3 Seconds
Bandwidth: 6 kHz Bridge time: 3 seconds
BFO: -1000 Hz Skip flag: off
AGC: ON IF Shift: 0 Hz
AGC decay: 60 ms Squelch: Lower limit
MGC: 0 dB
Utility - CONFIG - INIT Soft Key Menu.
CHNL SKIP MDFLTS SFLBLS CANCEL
MTR
MNU
NEXT
Press SKIP to initialize (clear) the sweep skip table of all frequencies for the sweep function. The following menu appears.
Utility - CONFIG - INIT - SKIP Soft Key Menu.
CONT CANCEL
MTR
MNU
NEXT
Press CONT to continue or CANCEL to cancel the function.
Courtesy of http://BlackRadios.terryo.org