Installation 23
Cat. No. 01016370
Installing Resin
1. Before adding the resin, verify that the correct type and amount of resin for
the softener you are installing is on site. Again, refer to the table on the pre-
vious page for the correct resin quantity. If the correct type and amount of
resin is not on site, contact the equipment provider.
2. Slowly pour in the correct amount of resin (see Figure 31). It is recommended
that a funnel be used on those units with hand-hole covers, when loading
resin into the resin tank. Make certain that no foreign material is left in the
resin tank.
3. Use a tape measure or measuring stick to verify the “M” or freeboard dis-
tance after the resin is installed. (See Figure 26 and Table 6 on page 21)
4. Do not install the hand-hole or manhole cover on the resin tank at this time.
Controller Mounting
The MVP controller is shipped in its own box, complete with transformer assembly, tubing assembly, mounting bracket,
and hardware.
1. Remove the controller mounting bracket from the shipping carton. If the conditioning cartridge option kit was
ordered, follow the instructions included with the kit to install the cartridge assembly on the mounting bracket.
2. Install the controller to the mounting bracket using the supplied hardware. Refer to Figure 32.
3. Install the bracket mounted controller to the Brunermatic valve using the supplied hardware.
4. Retain the other items in the shipping carton for future use.
B
O
T
4
T
O
P
6
2
O
U
T
D
R
1
5
I
17
N
BRUNERMATIC VALVE
MVP CONTROLLER
MOUNTING
BRACKET
SCREWS
SCREWS
#10-32 X 1/2
Figure 32.
Figure 31.
To Next Page
Loading...
Need help?
General
