Culligan CSM Series User Manual

32 Culligan® CSM Series Softeners
32 Cat. No. 01016370
Brine Refill Valve Wiring
1. Installation of the solenoid coil and connector
Locate the solenoid coil and connector cord. Assemble
it to the brine refill valve as shown in Figure 46.
2. Installation of the cord grip
Remove the hole plug from the left side of the MVP
controller enclosure. Locate the cord grip fitting and
nut. Assemble them through the open hole and thread
the solenoid coil cord through the cord grip fitting as
shown in Figure 47. Tighten the cord grip onto the
cord.
3. Wiring
Wire the circuit as shown in the diagram in Figure 48.
The wires can be trimmed to a suitable length.
Solenoid
Coil
Screw Plastic
Spacer
Figure 46.
Figure 47.
2.5VAC
P9 Power
24VAC
Vlv
Aux1
Sol
P7
Aux2
P8P5
Cam
P1
P10
Snsr
Aqua
Meter
P4
Flow
In
P2
Aux
LCD
TRIM OFF
GREEN WIRE
BLACK
WHITE
REFILL
SOLENOID
VALVE
CIRCUIT BOARD
MVP
Figure 48.

Culligan CSM Series Specifications

General

Brand	Culligan
Model	CSM Series
Category	Water Dispenser
Language	English