Culligan HE - Information

35
01021076
The following information can be displayed at the control valve or remote display. These settings are read-
only. Press or to scroll through the settings. Press to view the previous setting.
Screen Display Range Setting Description
SOFTENING
JAN-01-12 12:01P
N/A
1. From the HOME screen, press to view the main menu.
>1)INFORMATION
2)MANUAL MODE
1–6
2. The screen displays the main menu. Press to select
1)INFORMATION.
SALT TANK LEVEL
OK
OK,
Low
3. If a Salt Brine Tank is installed, this screen displays the
salt level. The status is OK unless the SBT probe detects
and overfilled brine tank or low salt level. If the screen
displays LOW a subsequent screen displays APPROX
DAYS OF SALT REMAINING. Press to select the
next information screen.
REMAIN CAPACITY
100%
0–100
4. The screen displays the softening capacity remaining,
displayed as a percentage of the total capacity. Dur-
ing manually initiated regeneration, assume 0 percent
remaining capacity. Press to select the next informa-
tion screen.
REMAIN CAPACITY
740 GAL
0–no
limit
5. The screen displays the softening capacity remaining,
measured in gallons (liters). Press to see the next
information screen.
CURRENT FLOWRATE
0.0 GPM
0–no
limit
6. The screen displays the current flow rate, measured in
gallons (liters) per minute. Press to see the next in-
formation screen.
TODAY’s USAGE
0 GAL
0–no
limit
7. The screen displays today’s water usage, measured in
gallons (liters). Press to see the next information
screen.
AVERAGE DAILY
300 GAL
0–no
limit
8. The screen displays average water usage for this con-
figuration. Press to see the next information screen.
Information