Cupra ATECA 2022 - Page 68

66
Opening and closing
A
Changing the battery
●
Unfold the vehicle key shaft.
●
Remove the cover from the back of the
vehicle key in the direction of the arrow
›››Fig.44 , ››› .
●
Remove the battery from the compartment
with a suitable ne object ›››Fig.45.
●
Fit a new button battery into the compart-
ment ››› .
●
Press the cover onto the key housing until it
clicks into place.
WARNING
Swallowing a battery with a 20 mm diameter
or any other button battery can cause seri-
ous and even fatal injuries within a very short
time.
●
Keep the vehicle key and key fobs with bat-
teries out of reach of children.
●
If you suspect that someone may have
swallowed a battery, seek immediate medical
attention.
NOTICE
●
If the battery is not changed correctly, the
vehicle key may be damaged.
●
Use of unsuitable batteries may damage
the vehicle key. For this reason, always re-
place the dead battery with another of the
same voltage, size and specications.
●
When tting the battery, check that the
polarity is correct.
For the sake of the environment
Please dispose of your used batteries cor-
rectly and with respect for the environment.
Synchronize the vehicle key
If the
button is pressed frequently outside of
the vehicle range, it is possible that the vehicle
can no longer be locked or unlocked using the
key. In this case, the key must be resynchron-
ised as described below:
●
Unfold the vehicle key blade ›››page64 .
●
If necessary, remove the cover from the
driver door handle ›››page75.
●
Press the button on the vehicle key. For
this, it must remain with the vehicle.
●
Open the vehicle within one minute using
the key blade. The key has been synchronised.
●
If necessary, t the cap.
Keyless Access system
Locking and unlocking with the
Keyless Access system
Fig.46 Keyless Access: proximity zones.
Fig.47 Driver door lever: sensor surfaces.
›››Fig.47
Unlocking sensor surface on the inside of
the door handle.