18
4. As the rope is tailed it should mound on the floor between the
operator and the cable puller.
5. Turn the cable puller switch to the
off position when the pull is completed.
Note: The Model 88 Cable Puller is equipped with a circuit breaker
switch. If the amperage rating of the breaker is exceeded the puller
will stop. Before restarting the pull, allow the motor to cool and
determine the cause for the overload condition. Correct before
restarting the pull.
This cable puller is equipped with an anti-reversin
pawl. The pawl will make a clickin
sound when the capstan is rotating. if
ou can not hear the clicking sound as the
capstan rotates, immediatel
turn the cable puller off and do not use until repaired
ARNIN
NEVER allow the rope to overlap on the capstan. If this condition be
ins to occur
immediatel
release the tailing force on the rope so that the rope can feed back toward
he conduit or cable tra
. If this does not remed
the overlap, turn off the cable puller
immediatel
. There is no known solution for ro
e overla
.
ARNIN
NEVER allow the rope to slip on a rotatin
capstan for more than a couple of seconds
The rope will wear in that spot and the rope could break under pressure. If
ou need
to sto
the
ull, turn the cable
uller off and tie the ro
e off to hold it in
lace until
ou restart
our pull
ARNIN
Keep all bod
parts, hair, loose clothing, etc. awa
from rotating parts and pinch
points. Keep hands awa
from capstan.
Do NOT wrap rope around an
bod
parts. Do NOT wrap rope around wrists
ALWAYS keep the tailing rope awa
from the operator
feet
ARNIN
OPERATING INSTRUCTIONS continued . . .
To Next Page
Loading...