INSTALLATION WALKTHROUGH:
For more information log onto www.curtmfg.com
3) Loosely install the supplied 7/16" hex flanges nuts. Torque
the 10mm fasteners to 45 lb.-ft. and all 7/16" fasteners to
60 lb.-ft.
Note: The small holes in the fascia tabs should be about
31.25" apart to line up with the fascia panel mounting holes.
4) Trim the lower plastic fascia as shown in the Panel Trim
Diagram to reinstall around the receiver tube of the hitch.
Reinstall lower plastic fascia with original fasteners.
To Next Page
Loading...
