curt 56093 - User Manual

56093-INS-RC
•
01/14/2021
•
ECN7905
•
PAGE 1 OF 7
Wiring Location Guide*
for SUVs and Vans (S)
S3 Behind driver side rear access panel
S4
Behind passenger side rear access panel
S9
S10
S5 S6 S7
S1
S3
S8
S4
S2
* Representative vehicle shown
INSTALLATION MANUAL
Tools Required
Ratchet Panel trim removal tool Wire crimper Paint marker
Socket, 8mm Pliers Wire stripper Electrical tape
Socket extension Cutting tool Heat gun --
Wiring Location(s)
P3 and P4, S3 and S4
Product Photo
Hardware Photo
WARNING
Do not exceed product rating or tow vehicle lamp load rating, whichever is lower.
The battery connection must be fuse-protected, 10-amp max. Exceeding
the product rating can cause loss of warranty, overheating and potential fire.
Maintenance
Periodic inspection of all wires and connections should be performed
to ensure there is no visible damage or loose connections.
Electrical Ratings
Signal circuits 3.0-amps per side
Tail / Running Circuits 6.0-amps total
Check vehicle owner's manual or contact
the vehicle manufacturer for more information.
Wiring Location Guide*
for Passenger Cars (P)
P3 Behind driver side taillight
housing, inside of trunk
P4 Behind passenger side taillight
housing, inside of trunk
P7
P1 P3 P4 P2
P5 P6
* Representative vehicle shown
NOTICE
Before you begin installation, read all instructions thoroughly.
Proper tools will improve the quality of installation and reduce the time required.
All steps must be followed to ensure the product will function properly. Once installed,
test for proper function by using a test light or connecting a properly wired trailer.
Level of Difficulty
Easy
Installation difficulty levels are based on time
and effort involved and may vary depending on
the installer level of expertise, condition of the
vehicle and proper tools and equipment.

Summary

Taurus Installation Steps

Step 1 A: Disconnect Battery

Locate vehicle's battery and disconnect the negative battery terminal.

Step 4 A: Connect Taillight Harness

Locate and separate taillight harness connectors, then insert custom wiring.

Step 5 A: Secure Ground Wire

Locate a suitable grounding point and secure the white ground wire with a screw.

Step 8 A: Final Connections and Reassembly

Explorer (10 th vin B, C, D) Installation Steps

Step 1 B: Disconnect Battery

Locate vehicle's battery and disconnect the negative battery terminal.

Step 4 B: Connect Taillight Harness

Loosen side wall panels, locate taillight housing connectors, insert custom wiring.

Step 5 B: Secure Ground Wire

Locate a suitable grounding point and secure the white ground wire with a screw.

Step 8 B: Final Connections and Reassembly

Explorer (10 th vin L) Installation Steps

Step 1 C: Disconnect Battery

Locate vehicle's battery, remove cover, and disconnect the negative battery terminal.

Step 4 C: Connect Taillight Harness

Loosen side wall panels, locate taillight housing connectors, insert custom wiring.

Step 5 C: Secure Ground Wire

Locate a suitable grounding point and secure the white ground wire with a screw.

Step 8 C: Final Connections and Reassembly

curt 56093 Specifications

General

Brand	curt
Model	56093
Category	Automobile Accessories
Language	English