56093-INS-RC
•
01/14/2021
•
ECN7905
•
PAGE 5 OF 7
Step 1C: Explorer (10th vin L)
Locate the vehicle's battery in the
engine compartment towards the back on
the passenger. The battery will be under a
cover. Push both tabs on the cover towards
the rear of the vehicle and lift. Once the cover
is removed, disconnect the negative battery
terminal. Be sure to fasten this wire down
and away from the battery while
completing the installation process.
Step 2C: Explorer (10th vin L)
Open the vehicle tailgate, fold the third row
seats forward and remove the floor coverings to
expose the spare tire. Use a panel trim removal
tool to remove the scuff panel by pulling out
on the bottom and then up. Take care not
to damage the alignment tabs on the back.
Step 3C: Explorer (10th vin L)
Use a pair of pliers to unthread the
screw behind this cargo net hold-down.
Use a panel trim removal tool to loosen
the cargo hook fastener cover. Use an
8mm socket to remove the cargo hook.
Repeat on the other side of the vehicle.
To Next Page
Loading...
Need help?
General
