56093-INS-RC
•
01/14/2021
•
ECN7905
•
PAGE 3 OF 7
Step 5A: Taurus
Locate a suitable grounding point near the connector such as an existing screw with nut in
the vehicle frame or drill a 3/32" pilot hole for the provided screw. The area should be free of
rust, dirt and paint. Secure the white ground wire using the ring terminal and provided screw.
WARNING
Check for miscellaneous items that may be hidden behind or under
any surface before drilling to avoid damage and / or personal injury.
Step 6A: Taurus
Route the green wire along the back of the vehicle under the scuff plate. Secure any loose wires
with the provided cable ties. Repeat step 4A on the passenger side with the green wire.
Step 7A: Taurus
Route the black power wire from the vehicle battery as shown on the provided 'Powered Converter Lead Instruction Sheet'.
Once 12 volt power wire is connected to the harness verify that the harness is functioning
by attaching the battery and testing with a test light, 4-flat tester or a functioning trailer.
Step 8A: Taurus
When in use, route the 4-flat to the center of the vehicle. When not in use, roll up and store
in a convenient, out of the way location. Secure any loose wires with the provided cable ties.
Reinstall all items removed during install. If it was disconnected at the beginning of the installation,
reconnect the negative battery terminal. Install the provided 4-flat dust cover to help prevent corrosion.
Step 1B: Explorer (10th vin B, C, D)
Locate the vehicle's battery in the engine
compartment on the driver side and disconnect
the negative battery terminal. Be sure to fasten
this wire down and away from the battery while
completing the installation process.
Step 2B: Explorer (10th vin B, C, D)
Open the vehicle tailgate, fold the third row
seats forward and remove the floor coverings to
expose the spare tire. Use a panel trim removal
tool to remove the scuff panel by pulling out
on the bottom and then up. Take care not
to damage the alignment tabs on the back.
To Next Page
Loading...
Need help?
General
