CURTMFG.COM
•
PRODUCT SUPPORT: 877.287.8634
•
57008-INS-RB
•
06/09/2020
•
PAGE 1
Product Registration and Warranty
CURT stands behind our products with industry-leading warranties. To get copies of the product
warranties, register your purchase or provide feedback, visit: warranty.curtgroup.com/surveys
INSTALLATION MANUAL
57008
Product Photo
WARNING
Do not exceed product rating or tow vehicle lamp load rating, whichever is lower.
NOTICE
Visit www.curtmfg.com for a full-color copy of this
instruction manual, as well as helpful videos, guides and much more!
Before you begin installation, read all instructions thoroughly.
Proper tools will improve the quality of installation and reduce the time required.
All steps must be followed to ensure the product will function properly. Once installed,
test for proper function by using a test light or connecting a properly wired trailer.
Level of Difficulty
Easy
Installation difficulty levels are based on time
and effort involved and may vary depending on
the installer level of expertise, condition of the
vehicle and proper tools and equipment.
Tools Required
Drill Drill bit, 7/64"
Hole saw, 2-1/8" Metal file
Flathead screwdriver Phillips screwdriver
Parts List
Item Qty Description
1 1 Extension harness
2 4 Self-tapping screws
3 8 Cable ties
Wiring Location(s)
T3
Wiring Location Guide*
for Trucks (T)
T1 Behind driver side taillight housing
T2 Behind passenger side taillight housing
T3 Behind driver side rear bumper
T4 Behind center of rear bumper fascia
T5 Behind passenger side rear bumper
T2
T4
T5
T1
T3
* Representative vehicle shown
To Next Page
Need help?
General
