CURTMFG.COM
•
PRODUCT SUPPORT: 877.287.8634
•
58266-INS-RB
•
02/18/2021
•
ECN7915
•
PAGE 1
Product Registration and Warranty
CURT stands behind our products with industry-leading warranties. To get copies of the product
warranties, register your purchase or provide feedback, visit: warranty.curtgroup.com/surveys
INSTALLATION MANUAL
58266
Product Photo
WARNING
Do not exceed product rating or tow vehicle lamp load rating, whichever is lower.
NOTICE
Visit www.curtmfg.com for a full-color copy of this
instruction manual, as well as helpful videos, guides and much more!
Before you begin installation, read all instructions thoroughly.
Proper tools will improve the quality of installation and reduce the time required.
All steps must be followed to ensure the product will function properly. Once installed,
test for proper function by using a test light or connecting a properly wired trailer.
When the hitch cover is flipped open to accept an
accessory, the inner tailgate panel will not operate.
When the hitch cover is closed, the inner taillgate panel will operate normally.
In either open or closed position the truck's taillights will
flash when the button on the truck or key fob is pushed.
Periodic inspection of all wires and connections should be
performed to ensure there is no visible damage or loose connections.
Level of Difficulty
Easy
Installation difficulty levels are based on time
and effort involved and may vary depending on
the installer level of expertise, condition of the
vehicle and proper tools and equipment.
Tools Required
Ratchet Torx bit, T-20
Socket, 1/2" Allen wrench, 5/32"
Socket extension Cutting tool
Parts List
Item Qty Description
1 1 Accessory sensor, top half
2 1 Accessory sensor, bottom half
3 1 Wiring harness
4 2 Socket head cap screw, 5/32"
5 2 Flat washer
6 2 Nylock nut
7 10 Zip tie
2
3
1
To Next Page
Need help?
General
