4
Curtis 1212S Manual, R ev. B
INSTALLATION AND WIRING
MOUNTING THE CONTROLLER
The 1212S controller can be oriented in any position, but the location should
be carefully chosen to keep the controller clean and dry. If a clean, dry
mounting location cannot be found, a cover must be used to shield the
controller from water and contaminants.
The outline and mounting hole dimensions are shown in Figure 2. The
controller should be mounted by means of the mounting holes at the opposing
corners of the base, using two M4 screws.
2
2 — INSTALLATION & WIRING
Fig. 2 Mounting
dimensions, Curtis 1212S
controller.
Dimensions in millimeters.
✭
You will need to take steps during the design and development of your
end product to ensure that its EMC performance complies with applicable
regulations; suggestions are presented in Appendix A.
To Next Page
Loading...
