Curtiss-Wright Parvus DuraNET 20-11 - MANAGEMENT INTERFACE OVERVIEW

Chapter 1 Introduction
Parvus DuraNET 20
-
11
Curtiss
-
Wright
Page 10 of 44 MNL-0656-01 Rev A8 ECO-N/A Effective: 16 Nov 21
MANAGEMENT INTERFACE OVERVIEW
The DuraNET 20-11 provides two types of user interfaces for switch configuration and management: a
serial command line interface (CLI) via RS-232 serial port, and a Web GUI via Ethernet. Each
management interface on the card connects to a host PC which acts as the console.
 Serial CLI: Connect to the host PC via a serial connector.
 Web GUI: Connect to the host PC via any one of the Ethernet ports.
Figure 2 illustrates the DuraNET 20-11 management interfaces. Chapter 4 explains how to use each
interface.
Figure 2. Management Interface Block Diagram
DuraNET 20-11 Gigabit
Ethernet Switch
Serial
Console
Port
Zeroize
Power
Supply
Port 1
Port 2
Port 3
Port 4
Port 5
Port 6
Port 7
Port 8
+5 to 36VDC Input
Active Low
t
e
x
t
t
e
x
t
J1
J2
Serial
Management
Console
(CLI)
End User
Equipment
Ethernet Web GUI
J0