Cuttermasters CM-01P User Manual

www.cuttermasters.com - Toll Free (800) 417 2171
CUTTERMASTER Professional CM-01P User’s Manual
Page 9
Free up the power cables and check them for damage. Read the appendix KB Control Board Manual
before operating. The internal circuit board trim pots have been set according to our preferences.
Note: Always check all wheel mounts, angular and rotational adjustmentool spindle for suit-
able tightness prior performing a grinding operation.
1.4 Care for your Machine
Themachineshouldbekeptfreeofdustanddebrisandwhennotinusealightlmofoil(e.g.WD-
40) should be applied to unprotected metal surfaces.
The assemblies are all steel and the threads should be kept clean and dry: a periodic cleaning by
spraying with WD-40 and then blown off with compressed air will keep the lead screws in good ser-
vice. Gibs should be free of dirt and slide freely.
Using the Tool Rest Assembly
The tool rest assembly is secured from stowed position to working position using the two thumb
screwsshownintherstimage.Besurethattheatfaceonthetoolrestbariscorrectlyaligned
to register with the ends of the set screws. When the tool rest is in stowed it is best snug but not to
tighten the thumbscrews. This preventool spindle marring the bar.
Tool Rest in Park Position
Tool Rest in Working Position
Tool Rest Thumb
Screws

Cuttermasters CM-01P Specifications

General

Brand	Cuttermasters
Model	CM-01P
Category	Grinder
Language	English