CyberPower PowerPanel User Manual

PowerPanel™ Business Edition
13
z Click the Finish button to complete the installation.
Note: The Linux installation will be also initiated by using the ./setup -c command.in text mode. The detailed
installation steps are described in Installation on VMWare ESX/ESXi 4 section.
Installation on VMWare ESX/ESXi 4
On VMWare ESX/ESXi, users may mount CD by using the mount command. Run mount /dev/scd0
/mnt/cdrom as a root user. /dev/scd0 is the CD drive and /mnt/cdrom will be the mount point.
Browse to the CD drive and find the installer named setup.sh in the /software/linux folder. The installer is
used to install the Client and requires root permission. The installation wizard will guide users to complete
the installation. Double click setup.sh or run the ./setup.sh command to initiate an installation procedure.
The installation procedure will be initiated as following steps:
z Press Enter to start an installation.

CyberPower PowerPanel Specifications

General

Operating System Compatibility	Windows, macOS, Linux
Battery Type	Sealed Lead-Acid (SLA)
Surge Protection	Yes
Category	Power Supply
Function	Uninterruptible Power Supply (UPS)
Features	Automatic Voltage Regulation (AVR), Battery Backup
Input Voltage	120V
Input Frequency	50/60Hz
Output Voltage	120V
Output Frequency	50/60Hz
Maximum Output Power	Varies by model (e.g., 1500VA, 1000W)
Battery Recharge Time	8 hours (typical)
Communication Port	USB
Dimensions	Varies by model
Weight	Varies by model