PowerPanel™ Business Edition
22
Pending Off: This outlet is going to turn off following an action such as a scheduled turn off.
Battery
z Status: Displays the present status of the battery packs.
Fully Charged: The batteries are at 100% capacity.
Discharging: The UPS is supplying battery power to support the load. This is caused by a utility
power failure or battery test.
Charging: The batteries are charging.
Capacity Critically Low: The batteries capacity is too low and the UPS may shut down immediately.
Not Present: There are no batteries present in the UPS.
Testing: The UPS is performing a battery diagnostic test. See the UPS/Diagnostics
page for more
details about the test results.
Normal: The batteries are working normally.
z Voltage: The present voltage supplied by the batteries.
z Remaining Runtime: The amount of time that the UPS can supply power to its load.
z Remaining Charge Time: The remaining time the batteries required to be fully charged.
z Capacity: The present capacity of the batteries expressed as a percentage of full charge.
System
z Status: Displays the present operating status of the UPS.
Normal: The operating status is normal.
Fault: The UPS is in fault state due to an internal malfunction.
Overheat: The temperature exceeds the normal temperature threshold.
z Temperature: The present internal temperature of the UPS. It is displayed in both Celsius (°C) and
Fahrenheit (°F).
To Next Page
Loading...
Need help?
General
