CyberPower SMART APP SINEWAVE UPS Series User Manual

14
Item Default Option Description
Battery Change Date ---/----  Month/Year
Optional setup information for users to record the
installation date of battery pack. Reset the data
when replacing new battery pack.
Schedule Test – On
Startup
No
 Yes
 No
If Yes is selected, the UPS will perform a Self Test
every time on startup.
Schedule Test –
Frequency
Never
 Never
 Every 1 week
 Every 2 weeks
 Every 3 weeks
 Every 4 weeks
Select the amount of time that the UPS will
perform Self Test periodically after startup.
Date and Time ----/--/-- --:--
 Year/Month/Day
Hour:Minute
Set the Date and Time for use in data/event logs.
Power Meter Reset No
 Yes
 No
Select Yes to reset the value of Load Energy in
Status Menu.
IP Access DHCP
 DHCP
 Manual IP Setup
Select the way to access the IP/Subnet
Mask/Gateway. This shows “No Web Device” when
no RMCARD is installed.
IP Address Auto-sensing
 Auto-sensing
 Manual Key-in
Change the IP Access setting to manual IP Setup
and then this item can be adjusted manually. This
shows “No Web Device” when no RMCARD is
installed.
Subnet Mask Auto-sensing
 Auto-sensing
 Manual Key-in
Change the IP Access setting to manual IP Setup
and then this item can be adjusted manually. This
shows “No Web Device” when no RMCARD is
installed.
Gateway Auto-sensing
 Auto-sensing
 Manual Key-in
Change the IP Access setting to manual IP Setup
and then this item can be adjusted manually. This
shows “No Web Device” when no RMCARD is
installed.
Firmware Update*
*Only displayed in
Standby Mode
No
 Yes
 No
Select Yes to update the firmware of UPS in
Standby Mode.
Back to Default No
 Yes
 No
Select Yes to restore the UPS factory default
settings.
LCD OPERATION GUIDE (continued)

CyberPower SMART APP SINEWAVE UPS Series Specifications

General

Brand	CyberPower
Model	SMART APP SINEWAVE UPS Series
Category	UPS
Language	English