46
Installing and Removing the Infant Carrier
Installing with Base Using Lap/Shoulder Belts
10. Check that the Recline
Angle remained in the
appropriate range for the
child's weight. If not, remove
Base, adjust recline angle
and reinstall.
Make sure that vehicle belt buckle and
hardware do not interfere with correct
installation of the Base or with the
connection of the Infant Carrier to the
Base.
11. Put vehicle belt in locked mode (see
vehicle Owner's Manual for more
information). In most vehicles, you can
switch the shoulder belt retractor into
locking mode by pulling out shoulder
belt all the way and then letting it rewind
into the retractor. Pull on the belt to
make sure it is locking.
12. If the Infant Carrier is next to a vehicle
door or panel, extend the adjacent L.S.P.
device (pg. 31).
ss
9 - 15.8 kg
(20 - 35 lbs)
1.8 - 9 kg
(4 - 20 lbs)
Recline Indicator
CY_171_8559_A0821
To Next Page
Loading...
