CYBEX gold CLOUD G User Manual

45
8. Grab the Base at the Belt Path and pull
from side to side and front to back to
make sure it is installed correctly. The
Base should not move more than 2.5 cm
(1 in) in any direction.
If the Base moves too much, open the
SafeLock Belt Tensioner and remove a
little more slack from the vehicle belt,
then close and recheck. After this, if
the Base still moves too much, you
may need to try a different vehicle seat
location or installation method, or both.
9. Squeeze the Release Button on the
Load Leg and extend it until the Foot
makes rm contact with vehicle oor.
Lock Leg into place using the rst hole
that will rmly lock it against the vehicle
oor.
It may be necessary to lift up slightly on
the Base to allow the Foot to lock into
the hole.
Installing and Removing the Infant Carrier
Installing with Base Using Lap/Shoulder Belts
ii
oo
Use the FIRST hole
that will lock the
Load Leg Foot rmly
against vehicle oor.

CYBEX gold CLOUD G Specifications

General

Brand	CYBEX gold
Model	CLOUD G
Category	Car Seat
Language	English