53
Installing and Removing the Infant Carrier
Installing the Infant Carrier Only Using Lap/Shoulder Belts
3. Lift shoulder belt over handle and around
Infant Carrier. Slide shoulder belt into the
blue Shoulder Belt Guide AA.
NOTE: Ensure that the shoulder belt is
routed below the L.S.P. System in either
the extended or retracted position.
4. Lock your vehicle lap shoulder belt.
Refer to your vehicle Owner's Manual
for how your vehicle lap and shoulder
belt locks.
In many vehicles, you can switch the
shoulder belt retractor into locking mode
by pulling the shoulder belt out all the
way. In some vehicles the buckle locks.
Check the vehicle Owner’s Manual to
see how your system locks.
To check if the vehicle belt is locked,
after you install the infant carrier, pull up
rmly on the lap belt between the Belt
Guides. The belt should remain tight if
the vehicle system is locked.
ee
AA
rr
To Next Page
Loading...
Need help?
General
