54
Installing and Removing the Infant Carrier
Installing the Infant Carrier Only Using Lap/Shoulder Belts
5. Push Infant Carrier rmly into vehicle
seat pressing down near the crotch
strap between the child’s legs A A while
removing slack from lap belt BB. Repeat
for shoulder belt.
6. Make sure that vehicle belt buckle and
hardware do not interfere with the Infant
Carrier.
7. Check the recline angle. Adjust the
seat angle until the BLUE LEVEL LINE
on the Infant Carrier is level with the
ground. A tightly rolled towel or pool
noodle (pg. 65) may be placed under the
Infant Carrier, near the vehicle seat back
to adjust the angle, if necessary.
NOTE: The CLOUD G/CLOUD G LUX
is allowed to touch the vehicle seat(s)
in front of it, as long the recline angle
of the CLOUD G/CLOUD G LUX is not
affected.
LINE MUST BE LEVEL WITH GROUN
WHEN INSTALLED WITHOUT BASE
FRONT OF VEHICLE
LINE MUST BE LEVEL WITH GROUND
WHEN INSTALLED WITHOUT BASE
FRONT OF VEHICLE
AA
BB
uu
tt
yy
To Next Page
Loading...
Need help?
General
