55
8. Grab the Infant Carrier at the Belt
Guides and pull from side to side and
front to back to make sure it is installed
correctly. The Infant Carrier should not
move more than 2.5 cm (1 in) in any
direction.
If the Infant Carrier moves too much,
tighten the vehicle belts more and
recheck. You may try a different vehicle
seat or installation method, or both.
9. If the Infant Carrier is next to a vehicle
door or panel, extend the adjacent L.S.P.
device (pg. 31).
Installing and Removing the Infant Carrier
Installing the Infant Carrier Only Using Lap/Shoulder Belts
Front of vehicle
oo
ii
To Next Page
Loading...
Need help?
General
