57
3. LOCK your vehicle lap shoulder belt. Refer
to your vehicle Owner's Manual for how
your vehicle lap and shoulder belt locks.
In many vehicles, you can switch the
shoulder belt retractor into locking mode by
pulling the shoulder belt out all the way. In
some vehicles the buckle locks. Check the
vehicle Owner’s Manual to see how your
system locks.
To check if the vehicle belt is locked, after
you install the infant carrier, pull up rmly
on the lap belt between the Belt Guides.
The belt should remain tight if the vehicle
system is locked.
4. Push Infant Carrier rmly into vehicle
seat, pressing down near the crotch strap
between the child’s legs, while removing
slack from lap belt AA. Repeat for shoulder
belt BB.
5. Make sure that vehicle belt buckle and
hardware DO NOT INTERFERE with the
Infant Carrier.
Installing and Removing the Infant Carrier
Installing the Infant Carrier Only Using Lap/Shoulder Belts (Alternate)
AA
BB
rr
tt
To Next Page
Loading...
Need help?
General
