60
Installing and Removing the Infant Carrier
Installing the Infant Carrier Without Base Using Lap Belt Only
3. Push Infant Carrier rmly into vehicle
seat, pressing down near the crotch
strap between the child’s legs, while
removing slack from the lap belt.
4. If necessary, tuck the loose end of the
lap belt out of the way.
5. Check the recline angle. Adjust the
seat angle until the BLUE LEVEL LINE
on the Infant Carrier is level with the
ground. A tightly rolled towel or pool
noodle (pg. 65) may be placed under the
Infant Carrier near the vehicle seat back
to adjust the angle.
The CLOUD G/CLOUD G LUX is
allowed to touch the vehicle seat(s) in
front of it, as long the recline angle of
the CLOUD G/CLOUD G LUX is not
affected.
LINE MUST BE LEVEL WITH GROUN
WHEN INSTALLED WITHOUT BASE
FRONT OF VEHICLE
LINE MUST BE LEVEL WITH GROUND
WHEN INSTALLED WITHOUT BASE
FRONT OF VEHICLE
ee
tt
To Next Page
Loading...
Need help?
General
