61
Installing and Removing the Infant Carrier
Installing the Infant Carrier Without Base Using Lap Belt Only
6. Grab the Infant Carrier at the Belt
Guides and pull from side to side and
front to back to make sure it is installed
correctly. The Infant Carrier should not
move more than 2.5 cm (1 in) in any
direction.
If the Infant Carrier moves too much,
tighten the vehicle belts more and
recheck. You may try a different vehicle
seat or installation method, or both.
7. If the Infant Carrier is next to a vehicle
door or panel, extend the adjacent L.S.P.
device (pg. 31).
uu
yy
To Next Page
Loading...
Need help?
General
