CYBEX gold SIRONA S User Manual

69
English
8. On buckle side, first lift up on shoulder belt to
remove slack in lap belt. Then remove slack
from shoulder belt on opposite side.
At this point, only remove slack from vehicle
belts, being careful not to overtighten them.
Belt Tensioner will tighten system fully. If
you have previously installed Restraint using
LATCH, make sure LATCH Strap lies flat on
bottom of the Base. See “To Store” section on
page 37.
Some vehicle lap/shoulder belts have a plastic
button or extra fold of webbing on the belt.
Do not allow these to interfere with belt
routing through Belt Tensioner. If they
interfere:
a. Use LATCH if within the weight limit, or
b. Move the child restraint to a dierent
location.
8
INSTALLING CHILD RESTRAINT WITH LAP/SHOULDER BELT
(PREFERRED METHOD)

CYBEX gold SIRONA S Specifications

General

Category	Convertible Car Seat
Height Limit	Up to 49 inches
Rotation	360-degree rotation
Harness Type	5-point harness
Child Height	Up to 49 inches
Direction	Rear-facing and Forward-facing
Installation	LATCH system
Safety Features	Energy-absorbing shell
Fabric	Machine washable cover
Standard	FMVSS 213
Headrest	Adjustable headrest
Child Age	Birth to 4 years approximately
Additional Features	Magnetic belt holders, Load leg base