42
t
Installing and Removing the Infant Car Seat
Installing with Base Using Rigid LATCH (Recommended Installation)
5. Press button on side of Rigid LATCH
and fully extend LATCH Connector.
Repeat for other side.
6. While holding Rigid LATCH, attach
both connectors to the vehicle lower
anchors. Each should make an audible
CLICK when attached. Make sure they
are attached by pulling rmly on the
connectors.
A GREEN indicator will be visible on the
release button when the Rigid LATCH
Connectors are attached to the lower
anchors.
NOTE: For installations
where vehicle lower
anchors may be difcult
to reach, you may obtain
LATCH Guides by calling
CYBEX Consumer
Services at 1-877-242-5676.
y
CLICK!
CLICK!
To Next Page
Loading...
