49
Installing and Removing the Infant Car Seat
Installing with Base Using Lap/Shoulder Belts
11. Press the release button on the Load Leg and extend it
until the Foot makes rm contact with vehicle oor. Lock
Leg into place using the rst hole that will rmly lock it
against the vehicle oor.
It may be necessary to lift up slightly on the Base to allow
the Foot to lock into the hole.
12. Place the Infant Car Seat into the Base, and listen for a
CLICK. Check that the Car Seat is installed by lifting up
on the Handle.
13. Check that the Recline Angle remains in the blue zone on
the Recline Indicator. If not:
• Remove the Infant Car Seat from the Base (pg. 64), unfasten the vehicle belt and
open the Safelock Belt Tensioner, adjust the Recline Foot, then repeat steps 5-13 to
reinstall, or
• Fully store the Recline Foot and use a tightly rolled towel or pool noodle under the
Base, near the vehicle seat back.
For more information, see "Adjusting the Recline Angle" on pg. 67.
14. Check that the L.S.P. System is being properly used (pgs. 32-33).
s
Use the FIRST hole that
will lock the Load Leg Foot
rmly against vehicle oor.
To Next Page
Loading...
