48
8. Press down on SafeLock Belt Tensioner until it locks into place.
If Belt Tensioner does not lock, try loosening the vehicle belt
slightly, then try to close again.
9. Grab the Base at the Belt Path and pull from side to side and
front to back to make sure it is installed correctly. The Base
should not move more than 2.5 cm (1 inch) in any direction.
If the Base moves too much, open the SafeLock Belt Tensioner
and remove a little more slack from the vehicle belt, then close
and recheck. After this, if the Base still moves too much, you may
need to try a different vehicle seat location or installation method,
or both.
10. LOCK your vehicle Lap/Shoulder Belt.
• In many vehicles, you can switch the
Shoulder Belt retractor into locking mode
by pulling the Shoulder Belt out all the
way.
• In some vehicles the buckle locks.
Refer to your vehicle Owner's Manual for
details.
Installing and Removing the Infant Car Seat
Installing with Base Using Lap/Shoulder Belts
i
o a
To Next Page
Loading...
